Siemens SIMATIC IPC647D

Technical specifications
8.6 BIOS description
SIMATIC IPC647D
178 Operating Instructions, 01/2014, A5E32996306-AA
Boot > Legacy
System parameters
Default settings
Local settings
Normal Boot Menu
Standard
Boot Type Order In the order of the
following Boot media
types:
Floppy drive Depending on
configuration
Hard Disk Drive Depending on
configuration
CD/DVD ROM Drive Depending on
configuration
USB Depending on
configuration
Others Depending on
configuration
Exit
System parameters
Default settings
Local settings
Profile:
8.6.7
Alarm, error and system messages
8.6.7.1
Power On Self Test
BIOS first performs a
P
ower
O
n
S
elf
T
est (POST) within the boot routine to verify proper
operation of certain functional units of the PC. The boot sequence is interrupted immediately
if a fatal error is detected.
BIOS initializes and tests further functional units if the POST does not return any errors. In
this startup phase, the graphics controller is initialized and any error messages are output to
the screen.
The error messages output by system BIOS are listed below. For information on error
messages output by the operating system or application programs, refer to the
corresponding manuals.