Siemens SIMATIC IPC647D

Expanding and assigning parameters to the device
6.2 Removing the front panel
SIMATIC IPC647D
62 Operating Instructions, 01/2014, A5E32996306-AA
6.2
Removing the front panel
Requirement
● The device is fully disconnected from the power supply, see chapter "Switching off the
device (Page 51)".
Procedure
Observe the chapter "ESD guideline (Page 119)".
1.
Open the front door at least 45°.
The interlock marked in the figure
then releases the front panel.
2.
Remove the front panel.
To do so reach into the fan slots.