Device maintenance and repair
7.4 Managing RAID systems
SIMATIC IPC647D
104 Operating Instructions, 01/2014, A5E32996306-AA
1. Install the bus frame.
2. Close the device.
3. When a processor is replaced, perform a BIOS update.
The microcode matching the processor is loaded in the process. The procedure is
described "Technical manual of the motherboard" document on the "Documentation and
Drivers" DVD.
If the installed processor is operated with a higher clock frequency than permitted, it can
be destroyed or cause loss of data.
Operate the processor only at a clock frequency that is equal to or less than the
permitted clock frequency.
Managing RAID systems
7.4.1
Example for a RAID1 system during the boot phase of the system
You can configure RAID hardware with <CTRL-I>. The associated description is available on
the "Documentation and Drivers" DVD.
To Next Page
Loading...
