Siemens SIMATIC IPC827D - Expanding and assigning parameters to the device

SIMATIC IPC627D/827D
Operating Instructions, 09/2014, A5E32990859-AB
59
Expanding and assigning parameters to the device
6
6.1
Opening the Device
CAUTION
The device contains electronic components which may be destroyed by electrostatic
charge.
You therefore need to take precautionary measures before you open the device. Refer to
the ESD guidelines on handling electrostatically sensitive components (Page 103).
Requirement
● The device is disconnect from the mains.
● All connecting cables are unplugged
● Screwdriver of type Torx T10
Limitation of liability
All technical data and approvals apply only to expansion units which are released by
SIEMENS.
Siemens disclaims any liability for impairment of functions caused by the use of third-party
devices or components.
Observe the installation instructions for the components. UL approval of the device only
applies when the UL-approved components are used according to their "Conditions of
Acceptability".