Device maintenance and repair
7.5 Installing the software
SIMATIC IPC627D/827D
96 Operating Instructions, 09/2014, A5E32990859-AB
1. Make sure that the partition on which you want to install the operating system is large
enough and is set up with a NTFS file system.
The recommended minimum size of this partition varies, depending on the operating
system, how much RAM you have available and how much additional software you want
to use. Information on how the data medium is partitioned in its factory state is available
in the tables below.
2. Select the partition on which you want to install the operating system.
3. Click "Next".
Installation is started. The Windows operating system is installed on the data medium.
Windows 7 partitions in the factory state
First BOOT 100 MB Automatically set up by installa-
Second SYSTEM 100 GB NTFS not compressed
Information for systems with RAID controller or AHCI controller
Data carrier controllers unknown to the operating system must be made known to the
operating system prior to installation in the "Install Windows" installation program.
You have copied the relevant controller driver to a USB stick.
1. Connect the USB stick with the controller driver to the device.
2. Start the "Install Windows" installation program as described above.
3. Select "Load Drivers" in the Windows installation window.
4. Select the respective driver on the USB stick.
Setting up the language selection by means of the Multilanguage User Interface
(MUI)
You can set the display of menus, dialogs or other information, such as date and time, to a
different language. For this purpose, you can either select one of the preinstalled languages
or install a new language package.
The following command sequences are described in English. Depending on the default
setting, they can be displayed in another language.
To Next Page
Loading...
