Siemens SIMATIC IPC827D - BIOS Update

Technical specifications
8.6 BIOS description
SIMATIC IPC627D/827D
156 Operating Instructions, 09/2014, A5E32990859-AB
Boot > Legacy
System parameters
Default settings
Local settings
Normal Boot menu
Standard
Boot Type Order
In the order of the following boot media:
Floppy drive
Depending on configuration
Hard Disk Drive Depending on configuration
CD/DVD ROM Drive
Depending on configuration
USB Depending on configuration
Others
Depending on configuration
Exit
System parameters
Default settings
Local settings
Profile:
8.6.6
BIOS update
Check regularly if updates are available for download to your device.
Additional information can be found on the Internet at the following address:After Sales
Information system (http://www.siemens.com/asis).
Noting down and restoring BIOS Setup settings
NOTICE
Irretrievable loss of data
All BIOS Setup settings are deleted after the BIOS update. This can put the system in an
undefined state. This may damage the device and the plant.
1. Print out the table in the next section "General BIOS Setup settings".
2. Enter your specific BIOS Setup setting in this table before you run a
BIOS update.
3. Start BIOS Setup after the BIOS update.
4. Load the BIOS Setup default settings with <F9> "Setup Defaults". Or use the BIOS
Setup command "Load Optimal Defaults" in the "Exit" menu.
5. Make your own Setup settings based on the table you have printed out.
6. Save the BIOS Setup settings with <F10> "Save and Exit".