Safety Instructions   
2.1 General safety instructions 
  SIMATIC IPC847D 
30  Operating Instructions, 01/2014, A5E32997454-AA 
 
Damage to the device, machine or plant due to device and system expansions 
Device and system expansions may contain faults and affect the entire device, machine or 
plant. 
Device and system expansions may violate safety rules and regulations regarding radio 
interference suppression. If you install or replace device or system expansions and damage 
your device, the warranty is voided.  
Note the following: 
•  Only install device or system expansions designed for this device. Contact your 
technical support team or the point of sale to find out which device and system 
expansions are suitable for installation. 
•  Observe the information on electromagnetic compatibility provided in the technical 
specifications. 
 
Fire hazard due to overheating of the device 
Expansion cards generate additional heat. The device can overheat or cause a fire. 
•  Observe the safety and installation instructions for the expansion cards. 
•  If necessary, install the device in an enclosure that meets the requirements of 
paragraphs 4.6 and 4.7.3 of the standards EN 60950-1:2006 and IEC/UL/EN/DIN-EN 
60950-1. 
 
Risk of explosion and release of harmful substances 
Improper handling of lithium batteries can result in an explosion of the batteries.  
Explosion of the lithium batteries and the resulting release of harmful substances can cause 
severe physical injury. Damaged batteries jeopardize the function of the device. 
Note the following when handling lithium batteries: 
•  Replace used batteries in good time; see the section "Replacing the backup battery" in 
the section "Device maintenance and repair". 
•  Replace the lithium battery only with an identical battery or types recommended by the 
manufacturer (order no.: A5E00047601). 
•  Do not throw lithium batteries into fire, do not solder on the cell body, do not recharge, 
do not open, do not short-circuit, do not reverse polarity, do not heat above 100°C and 
protect from direct sunlight, moisture and condensation.