Siemens SIMATIC IPC847D - Removing and Installing Drives in the Internal Drive Cage

Expanding and assigning parameters to the device
6.5 Drives
SIMATIC IPC847D
82 Operating Instructions, 01/2014, A5E32997454-AA
6.5.4
Removing and installing drives in the internal drive cage
Requirement
● The device is opened.
Procedure - removing drive
1.
Remove the card retainer.
2.
Remove the four screws ①
.
3.
Then disconnect the power cable
and
the data cable from the
installed drives.
4.
Take the drive cage out of the
housing.
Installing a drive
1.
Push the drive into the bay from
the front.
2.
Secure the drive with four screws
to the drive cage.
3.
Connect the power cable and the
data cables to the drive.
4.
Install the drive cage again.