Siemens SIMATIC IPC847D - COM, DP, DVI;VGA, PS;2 and Audio Cables; Multi-Monitoring

Installing and connecting the device
3.3 Connecting the device
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
51
3.3.6.4
COM, DP, DVI/VGA, PS/2 and audio cables
Cable ties are included in the accessories kit for the interfaces. These cable ties can be
installed on the rear panel, if necessary.
Procedure
1. Insert the supplied strain relief into bore
① or ② of the rear panel.
2. Fasten the cables with the cable ties to the strain relief.
3.3.7
Multi-monitoring
You can operate up to five monitors simultaneously at the interfaces of the integrated
graphics controller in combination with the optional graphics card. Parameter assignment is
performed by means of the Control Panel in Windows.
The following monitors can be operated simultaneously on the motherboard:
● 2 × DisplayPort, 1 × DVI
● 2 × DisplayPort, 1 × VGA
● 1 × DisplayPort, 1 × DVI via DisplayPort-DVI adapter, 1 × DVI
● 1 × DisplayPort, 1 × VGA via DisplayPort-VGA adapter, 1 × DVI/VGA
Note
The motherboard supports up to one additional DVI monitor if it is connected by means of a
passive DisplayPort
-DVI adapter.