Siemens SIMATIC IPC847D - Replacing Filters

Device maintenance and repair
7.2 Maintenance
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
89
7.2.2
Replacing filters
Requirement
Note
You may only use filters of the same type. Information about the original spare parts for
SIMATIC PCs is available in the Internet at SIMATIC IPC
after-sales information system
(
http://www.siemens.com/asis).
Filter meshes are available under the following order number: A5E01064980.
Procedure
1.
Open the front door
② until the
latch ① releases the fan cover.
2.
Remove the fan cover.
3.
Change the filter pad, if
necessary. It is inserted loosely
in the fan cover. When you insert
the filter pad, make sure it lies
evenly in the fan cover.
Note
Use of the filter pad
We advise against using filter pads that have already been used. If you do want to refit a
filter pad you have removed, however, take account of the direction in which the fan draws
air into the device. Make absolutely certain
that you do not fit the outer side of the filter pad
on the inside. Generally, the outer side is clearly dirty after it has been in use for some time.