Installing and connecting the device
3.2 Mounting the device
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
39
Optional mounting methods
Options of mounting the device
● Mounting on cabinet brackets
● Mounting on device bases
● Tower installation: a tower kit can be ordered separately for this (not available in some
countries)
● Mounting on telescopic rails
When telescopic rails are used for mounting, the device can be withdrawn fully from the
cabinet or rack.
For detailed information on telescopic rails, see the sections Technical data of the
telescopic rails (Page 130) and Dimensional drawing for the use of telescopic rails
(Page 120).
The mounting screws of the telescopic rails may not protrude more than 5 mm into the
enclosure.
It is not permitted to install the device only on the 19-inch brackets of the front panel.
Note
For vertical operation, install the device on a
horizontal metal base and secure it against
tilting. The following RITTAL module panels are available:
7000.620, Rittal type VR 5501.655, Rittal type DK 5501.655. Note the
information of the switch cabinet supplier.
To Next Page
Loading...
