Siemens SIMATIC S7-300 Module data Hardware And Installation Manual

Commissioning
S7-300 Programmable Controller Hardware and Installation
8-14 A5E00105492-01
Table 8-3 Possible causes of a CPU request to reset memory
Causes of a CPU request to reset
memory
Remarks
The Memory Card or MMC has been
replaced.
not with CPU 312 IFM /
314 IFM (314-5AE0x)
RAM error in CPU –
Main memory too small, that is not all
user program blocks on a Memory
Card or MMC could be loaded.
Attempts to load faulty blocks; e.g. if
the wrong instruction was
programmed.
CPU with inserted 5-V FEPROM Memory Card
(not CPU 31x)
With these causes the CPU requests one
memory reset. After that, the CPU ignores the
contents of the memory card, enters the error
reasons in the diagnostics buffer and goes to
STOP. You can erase or reprogram 5-V
FEPROM Memory Card in the CPU.
CPU 31xC with inserted MMC: Continuous
request to reset memory.
Additional information on MMC behavior after
memory reset is found in the Reference Manual
CPU Data , Chapter memory Conception.
How to reset memory
There are two ways of resetting CPU memory:
Memory reset with the mode selector
switch
Memory reset with PG
... is described in this Chapter. ... only possible if the CPU is in STOP mode
(seeSTEP 7 Online Help).

Siemens SIMATIC S7-300 Module data Specifications

General

Series	S7-300
Manufacturer	Siemens
Protection Class	IP20
System	SIMATIC S7-300
Digital Inputs	Varies by module
Digital Outputs	Varies by module
Analog Inputs	Varies by module
Analog Outputs	Varies by module
Central Processing Unit	Varies by CPU model
Supply Voltage	24V DC or 120/230V AC
CPU Type	Varies (e.g., CPU 312, CPU 315, etc.)
Memory	Varies by CPU model
Communication Interfaces	MPI, PROFIBUS
Programming Languages	LAD, FBD, STL, SCL, GRAPH
Operating Temperature	0°C to 60°C
Storage Temperature	-40°C to 70°C
Relative Humidity	10% to 95% (non-condensing)