Siemens SIMOTICS M-1PH8 Configuration Manual

Standards that are complied with
Note
The standards listed in this manual are not dated.
You can take the currently relevant and valid dates from the Declaration of Conformity.
The motors of the type series SIMOTICSS, SIMOTICSM, SIMOTICSL, SIMOTICST, SIMOTICSA,
called "SIMOTICS motor series" below, ful󹪝ll the requirements of the following directives and
standards:
• EN60034‑1 - Rotating electrical machines – Dimensioning and operating behavior
• EN 60204‑1 - Safety of machinery – Electrical equipment of machines; general requirements
Where applicable, the SIMOTICS motor series are in conformance with the following parts of
EN60034:
Feature Standard
Degree of protection EN60034‑5
Cooling
1)
EN60034‑6
Type of construction EN60034‑7
Connection designations EN60034‑8
Noise levels
1)
EN60034‑9
Temperature monitoring EN60034‑11
Vibration severity grades
1)
EN60034‑14
1)
Standard part, e.g. cannot be used for built-in motors.
Relevant directives
The following directives are relevant for SIMOTICS motors.
European Low-Voltage Directive
SIMOTICS motors comply with the Low-Voltage Directive 2014/35/EU.
European Machinery Directive
SIMOTICS motors do not fall within the scope covered by the Machinery Directive.
However, the use of the products in a typical machine application has been fully assessed for
compliance with the main regulations in this directive concerning health and safety.
European EMC Directive
SIMOTICS motors do not fall within the scope covered by the EMC Directive. The products
are not considered as devices in the sense of the directive. Installed and operated with
a converter, the motor - together with the Power Drive System - must comply with the
requirements laid down in the applicable EMC Directive.
European RoHS Directive
The SIMOTICS motor series complies with the Directive 2011/65/EU regarding limiting the use
of certain hazardous substances.
Motor description
3.2Technical characteristics and environmental conditions
1PH8 SIMOTICS M main motors
Con󹪝guration Manual, 12/2022, A5E51895839A 27

Siemens SIMOTICS M-1PH8 Specifications

General

Brand	Siemens
Model	SIMOTICS M-1PH8
Category	Engine
Language	English