Siemens SIMOTICS M-1PH8 - Article No. Supplements for SH 180 to 225 + Holding Brake

3.4.8 Article No. supplements for SH 180 to 225 + holding brake
Descriptions Data position of the order No.  
  1 2 3 4 5 6 7 - 8 9 10 11 12 - 13 14 15 16 - Z
 1 P H 8                
Shaft height 180 1 8
Shaft height 225 2 2
Overall length
Induction version with holding brake
1)
3
Synchronous version with holding brake
1)
4
Encoder sys‐
tems
for motors
without a
DRIVE-CLiQ in‐
terface
without encoder
2)
A 2
Absolute encoder EnDat 2048 S/R (encoder AM2048S/R) E 2
Incremental encoder HTL 1024 S/R (encoder
HTL1024S/R)
2)
H 2
Incremental encoder HTL 2048 S/R (encoder
HTL2048S/R)
2)
J 2
Incremental encoder sin/cos 1 V
pp
, 2048 S/R with C and D
track (encoder IC2048S/R)
M 2
Encoder sys‐
tems
for motors with
a
DRIVE-CLiQ in‐
terface
Absolute encoder, 22-bit singleturn + 12-bit multiturn (en‐
coder AM22DQ)
F 1
Incremental encoder, 22-bit, with commutation position
(encoder IC22DQ)
D 1
Winding version 
Cooling Forced ventila‐
tion, DE-->NDE
(degree of protection IP 55) 0
Forced ventila‐
tion, NDE-->DE
(degree of protection IP 55) 1
Water cooling (degree of protection IP 55) 2
Open-circuit
ventilation,
NDE-->DE (in‐
duction version
only)
(degree of protection IP 23) 4
Type of con‐
struction
IM B3 (IM B6, IM
B7, IM B8)
 0
Shaft exten‐
sion (DE)
Balancing 
Fitted key Half-key  2
Bearings Vibration se‐
verity acc. to
Siemens/EN
60034-14
Shaft and
󹪞ange accuracy

Standard A N  A
Power connec‐
tion
3)
Cable entry Signal connec‐
tion
(looking onto DE)
Motor description
3.4Selection and ordering data
1PH8 SIMOTICS M main motors
Con󹪝guration Manual, 12/2022, A5E51895839A 55