Siemens SIMOTICS M-1PH8 - Page 48

Descriptions Data position of the order No.  
 1 2 3 4 5 6 7 - 8 9 10 11 12 - 13 14 15 16 - Z
Version 
Without a DRIVE-CLiQ interface, PT1000 temperature sensor in the stator winding 2
With a DRIVE-CLiQ interface 1
Special version (order codes are required for options) Z
1) Only possible if the 8th data position is "1" (induction version)
4) Limited to n
max
= 4600r/min
5) Limited to n
max
= 3000r/min, not possible if 14th data position is "L" (Performance).
6) Limited to n
max
= 2500r/min, not possible if 14th data position is "L" (Performance).
7) Limited to n
max
= 2000r/min
8) Only possible with shaft height 180: Limited to n
max
= 7500r/min,
not possible if the 12th data position is "2" (IM B5) and the 11th data position is "3" and "4" (open-circuit ventilation)
only possible for shaft height 225: Limited to n
max
= 6000r/min,
not possible if the 12th data position is "2" (IM B5) and the 11th data position is "3" and "4" (open-circuit ventilation)
9) Only possible if 14th data position is "A" or "B" (standard bearings)
Motor description
3.4Selection and ordering data
1PH8 SIMOTICS M main motors
46 Con󹪝guration Manual, 12/2022, A5E51895839A