What to do if Siemens SINAMICS G120D shows F30004 error?
To troubleshoot the F30004 fault on your Siemens Media Converter, start by checking if the converter fan is running and ensure the ambient temperature is within the allowed range. Also, verify that the motor isn't overloaded and consider reducing the pulse frequency.
What to do if Siemens Media Converter displays 'STOP cam approached with the incorrect traversing direction'?
If your Siemens Media Converter displays 'STOP cam approached with the incorrect traversing direction', check the wiring of the STOP cam.
How to troubleshoot F08700 fault in Siemens Media Converter?
To address the F08700 fault on your Siemens Media Converter, check the bus cable, baud rate (p8622), and bit timing (p8623). Also, verify the master. After resolving the cause of the fault, manually start the CAN controller with p8608 = 1.
What to do if Siemens SINAMICS G120D Media Converter displays F30015 error?
To address the F30015 fault on your Siemens Media Converter, check the motor cables and increase the ramp-up or ramp-down time (p1120).
What to do if Siemens Control Unit displays 'Consistency error affecting adjustable parameters'?
If your Siemens Control Unit displays 'Consistency error affecting adjustable parameters', check the following: IP address, subnet mask or default gateway is not correct; IP address or station name used twice in the network; Station name contains invalid characters.
How do I fix 'Frequency at the probe input too high' on my Siemens Control Unit?
To resolve the 'Frequency at the probe input too high' error on your Siemens Control Unit, reduce the frequency of the pulses at the probe input.
What to do if Siemens SINAMICS G120D displays 'Supply voltage (p0210) incorrectly parameterized'?
If your Siemens Media Converter displays 'Supply voltage (p0210) incorrectly parameterized', check the parameterized supply voltage and change it if required. Also, check the line voltage.
What to do if Siemens Media Converter displays 'Setpoint timeout'?
If your Siemens Media Converter displays 'Setpoint timeout', check the PROFINET connection. Set the controller to RUN mode. If the error occurs repeatedly, check the monitoring time set.
How do I troubleshoot F01122 fault on a Siemens SINAMICS G120D?
To resolve the F01122 fault on your Siemens Media Converter, reduce the frequency of the pulses at the probe input.
How to clear F01600 fault on Siemens SINAMICS G120D Media Converter?
To resolve the F01600 fault on your Siemens Media Converter, select STO and then deselect again.
General| Brand | Siemens |
|---|---|
| Model | SINAMICS G120D |
| Category | Media Converter |
| Language | English |
Essential safety guidelines for operating electrical devices and preventing hazards.
Provides essential guidelines for electrical connections, including line supplies and EMC rules.
Outlines the steps for performing basic commissioning using the STARTER software tool.
Details the setup and function of the fail-safe digital input for STO safety.
Covers communication setup, functions, and requirements for PROFINET integration.
Details requirements, integration, and configuration for PROFIBUS communication.
Explains how to switch the motor on/off and manage converter states and commands.
Describes the EPOS function, operating modes, commissioning, and configuration of positioning.
Explains the STO safety function, its principle of operation, and commissioning procedures.
Details how the inverter signals faults, the fault buffer, and how to acknowledge and delete faults.
Details recommended procedures for testing safety functions and documenting results.
To Next Page