What causes 'DC-link voltage overvoltage' in Siemens Control Unit and how to fix it?
If your Siemens Control Unit reports a DC-link voltage overvoltage, try the following: Increase the ramp-down time (p1121), set the rounding times (p1130, p1136), activate the DC link voltage controller (p1240, p1280), check the line voltage (p0210), and inspect the line phases.
General| Brand | Siemens |
|---|---|
| Model | SINAMICS G120D |
| Category | Media Converter |
| Language | English |
Essential safety guidelines for operating electrical devices and preventing hazards.
Provides essential guidelines for electrical connections, including line supplies and EMC rules.
Outlines the steps for performing basic commissioning using the STARTER software tool.
Details the setup and function of the fail-safe digital input for STO safety.
Covers communication setup, functions, and requirements for PROFINET integration.
Details requirements, integration, and configuration for PROFIBUS communication.
Explains how to switch the motor on/off and manage converter states and commands.
Describes the EPOS function, operating modes, commissioning, and configuration of positioning.
Explains the STO safety function, its principle of operation, and commissioning procedures.
Details how the inverter signals faults, the fault buffer, and how to acknowledge and delete faults.
Details recommended procedures for testing safety functions and documenting results.
To Next Page