What should I check if my Siemens SINAMICS G120D displays 'Motor overtemperature'?
If your Siemens Media Converter indicates a motor overtemperature, you should reduce the motor load, verify the ambient temperature, and inspect the wiring and connection of the temperature sensor.
What should I do if my Siemens Control Unit displays 'STOP A Triggered'?
If your Siemens Control Unit displays 'STOP A Triggered', select STO and then deselect it again.
What to do if Siemens Control Unit displays 'DC link overvoltage'?
If your Siemens Control Unit displays 'DC link overvoltage', check the device supply voltage (p0210) and the line reactor dimensioning.
What to do if Siemens Control Unit displays 'Internal fan defective'?
If your Siemens Control Unit displays 'Internal fan defective', check the internal fan and replace it if necessary.
What to do if Siemens Control Unit displays 'Rectifier overtemperature'?
If your Siemens Control Unit displays 'Rectifier overtemperature', see F30035 and, in addition: Check the motor load and the line phases.
What to do if Siemens Control Unit displays 'Overtemperature, intake air'?
If your Siemens Control Unit displays 'Overtemperature, intake air', check whether the fan is running, inspect the fan filter elements, and ensure the ambient temperature is within the permissible range.
What to do if Siemens Control Unit displays 'Motor cable phase failure'?
If your Siemens Control Unit displays 'Motor cable phase failure', check the motor cables and increase the ramp-up or ramp-down time (p1120).
What to do if Siemens Control Unit displays 'I2t converter overload'?
If your Siemens Control Unit displays 'I2t converter overload', check the rated currents of the motor and Power Module. Reduce current limit p0640. When operating with U/f characteristic: Reduce p1341.
What to do if Siemens Control Unit displays 'Torque/speed too low'?
If your Siemens Control Unit displays 'Torque/speed too low', check the connection between the motor and the load. Adapt the parameterization corresponding to the load.
What to do if Siemens Control Unit displays 'Motor speed deviation'?
If your Siemens Control Unit displays 'Motor speed deviation', increase p2163 and/or p2166. Increase the torque, current and power limits.
General| Brand | Siemens |
|---|---|
| Model | SINAMICS G120D |
| Category | Media Converter |
| Language | English |
Essential safety guidelines for operating electrical devices and preventing hazards.
Provides essential guidelines for electrical connections, including line supplies and EMC rules.
Outlines the steps for performing basic commissioning using the STARTER software tool.
Details the setup and function of the fail-safe digital input for STO safety.
Covers communication setup, functions, and requirements for PROFINET integration.
Details requirements, integration, and configuration for PROFIBUS communication.
Explains how to switch the motor on/off and manage converter states and commands.
Describes the EPOS function, operating modes, commissioning, and configuration of positioning.
Explains the STO safety function, its principle of operation, and commissioning procedures.
Details how the inverter signals faults, the fault buffer, and how to acknowledge and delete faults.
Details recommended procedures for testing safety functions and documenting results.
To Next Page