Siemens SINAMICS S120 - Page 153

Diagnostics
5.3 Diagnostics via Startdrive
Commissioning with Startdrive
Commissioning Manual, (IH3), 07/2016, 6SL3097-4AA10-0BP0
153
The following table lists the possible icon colors with their significance. For more information
on this topic, refer to the online help in the TIA Portal, which you can call up using the icon
tooltips.
Icon color
Meaning
OK = no fault active or maintenance is required
Maintenance required
Alarm or request for maintenance
Communication error or topological error
No diagnostic capability
Display messages
Proceed as follows to display messages, which are assigned to an icon:
1. Double click the icon.
The "Display message" tab is moved into the foreground of the Inspector window.
All pending messages are displayed there.
Errors in the DRIVE-CLiQ connections of the drive lineup
All DRIVE-CLiQ components of the drive lineup are displayed in the device view. If the
DRIVE-CLiQ connections of the offline configuration differ from the actual wiring, then these
errors are displayed in the device view. The DRIVE-CLiQ connections are aligned online
(reference-actual).
If you call the tooltip of an incorrectly interconnected port, then you are provided with a
description of the error cause (reference-actual alignment). You must either change the
connections (wiring) at the device, or in the device view.