Commissioning
4.3 Creating a project
Commissioning with Startdrive
66 Commissioning Manual, (IH3), 07/2016, 6SL3097-4AA10-0BP0
Specifying the infeed unit space holder
Up until now, only an unspecified component envelope (space holder) exists. This
component envelope must now be specified in more detail by using an article number so that
the components in the device view correspond to what you have installed in your actual drive
system.
Based on the color of the component envelope you can identify as to whether a component
has been specified or not specified:
● White = component is not specified
● Dark gray = component is specified
Assigning the correct variant to the placeholder (specifying)
To specify, proceed as follows:
1. Click in the inner white area of the unspecified component envelope.
Figure 4-10 Unspecified module
The area is shown as selected.
2. Open the inspector window if it has still not been opened or displayed.
To Next Page
Loading...
