Commissioning
4.3 Creating a project
Commissioning with Startdrive
72 Commissioning Manual, (IH3), 07/2016, 6SL3097-4AA10-0BP0
Inserting a motor module
Requirement
● A project has been created.
● A control module (drive) has been inserted in the device configuration.
● An infeed unit is inserted.
In case of doubt, you can also add the infeed unit at a later point in time. However, in this
case, you must manually wire the "infeed unit" component with the other components.
Inserting and specifying a Motor Module
Using the hardware catalog, you insert a Motor Module in an unspecified form.
1. Open the "Motor Modules" entry in the hardware catalog.
A selection can be made from the following Motor Modules:
– Single Motor Modules
– Double Motor Modules
2. Select the required, unspecified Motor Module in the device overview.
Figure 4-17 Motor Module selected
Ensure that the module supports the required control mode when making your selection.
To Next Page
Loading...
