Siemens SINAMICS S120 - Drive Control Panel

Startdrive commissioning tool
2.5 Drive control panel
Commissioning with Startdrive
Commissioning Manual, (IH3), 07/2016, 6SL3097-4AA10-0BP0
43
2.5
Drive control panel
The drive control panel (see Chapter "Using the control panel (Page 105)") is used to control
and monitor individual drives. You traverse drives with the control panel by specifying values.
Depending on the operating mode, these are, for example, speed setpoints.
The following figure shows the various components of the control panel:
①
Activate/deactivate master control
②
Switch infeed on and off
③
Set drive enable
④
Select operating mode
⑤
Drive ON/OFF
⑥
Control drive
⑦
Drive status
⑧
Actual values
Figure 2-11 Control panel