Siemens SINAMICS V10 - Operation Mode 2: Connection Macro Selection

Parameter setting in "Quick motor data setting" mode
Example: P0304
Press
Press
OK
Press
(Default)
OK
OK
OK
OK
OK
. . .
$OWHUQDWLYH&RQWLQXRXVO\WXUQWLOOWKHYDOXHGHVLUHGDSSHDUV
$OWHUQDWLYH&RQWLQXRXVO\SUHVVWRPRYHWKHFXUVRUDPRQJGLJLWVWKHQSRVLWLRQWKHFXUVRU
RQWKHGHVLUHGGLJLW3URFHHGZLWK$OWHUQDWLYHRU$OWHUQDWLYH
7KUHHDOWHUQDWLYHVWRVHWDYDOXH
$OWHUQDWLYH&RQWLQXRXVO\WXUQIRUDZKLOHWKHQSUHVVWRYLHZWKHQH[WLPPHGLDWHO\
IROORZHGDQGDYDLODEOHYDOXH,IWKLVYDOXHLVVWLOOQRWZKDW\RXZDQWUHSHDWWKHDIRUH
VDLGRU$OWHUQDWLYHWLOOWKHULJKWYDOXHDSSHDUV
SET
Figure 6-19 Parameter setting example (P0304)
Note
The value set by pressing OK will be displayed by default next time.
The digit bit can be dynamically changed according to the parameter value.
Button/keys inactive in this mode
The STOP, RUN and LOC/REM keys are inactive in this mode.
6.6.2 Operation mode ② - Connection macro selection
ᴀഄ
Connection macro selection
. . .
OK
Turn
OK
Turn
OK
Turn
OK
Turn
Figure 6-20 Connection macro selection
Commissioning
6.6 Overview of various operation modes
SINAMICS V10
Operating Instructions, 08/2011, A5E03453178 (this is not an order number) 67