Parameter No. Name
P0290 Inverer overload reaction
P0294 Inverter I
2
T overload warning
P0610 Motor I
2
T reaction
P0611 Motor I
2
T time constant
P0640 Motor overload factor
Table 7-8 Other parameters
Parameter No. Name
P0005 Display selection
P0970 Factory reset
P0971 Transfer data from RAM to EEPROM
P1080 Min. frequency
P1082 Max. frequency
P1120 Ramp-up time
P1121 Ramp-down time
P1200 Flying start
P1202 Motor-current: Flying start
P1203 Search rate: Flying start
P1210 Automatic restart
P1240 Configuration of Vdc controller
P1300 Control mode
P1800 Pulse frequency
P2000 Reference frequency
P2280 PI proprotion gain
P2285 PI integral time
P2293 Ramp-up/-down time of PI limit
Notes on the OFF functions
OFF1 - This command (produced by cancelling the ON command) causes the inverter to come
to a standstill at the selected ramp-down rate. (Active by pressing STOP for less than 2
seconds)
OFF2 - This command causes the motor to coast to a standstill. (Active by pressing STOP for
more than 2 seconds) Both OFF2 and OFF3 are effective at low voltage, and OFF2 enjoys the
highest priority.
OFF3 - This command causes the motor to decelerate rapidly.
Parameter list
SINAMICS V10
78 Operating Instructions, 08/2011, A5E03453178 (this is not an order number)
To Next Page
Loading...
