Siemens SINAMICS V10 - Page 79

Parameter list
Table 7-9 Parameter list
Par. No. Name Range Default Unit
r0002 Inverter state -- -- --
Displays actual inverter state.
0 Commissioning mode
1 Inverter ready
2 Inverter fault active
3 Inverter starting (DC-link precharging)
4 Inverter running
5 Stopping (ramping down)
P0005 Display selection 21 - 27 21 --
Selects display of the user-selected output
21 Actual frequency
25 Output voltage
26 DC link voltage
27 Output current
r0007 Selected connection macro and application macro C0100 - C1005 C0100 --
Displays selected connection macro and application macro
C0100 Connection macro C01 and application macro A00 are selected
C0101 Connection macro C01 and application macro A01 are selected
…
C1005 Connection macro C10 and application macro A05 are selected
Note:
Default value depends on selected connection macro and application macro.
P0011 Lock for user-defined parameter 0 - 65535 0 --
Password to lock user-defined parameter.
P0012 Key for user-defined parameter 0 - 65535 0 --
Password to unlock user-defined parameter.
Parameter list
SINAMICS V10
Operating Instructions, 08/2011, A5E03453178 (this is not an order number) 79