Siemens SINAMICS V10 - Control Parameters; Protection Specific Parameters

Parameter No. Name
P1135 OFF3 ramp-down time
P0840 Selection of the ON/OFF1 command source
P0844 Selection of the OFF2 command source
P1032 Inhibiting negative set points of MOP
Table 7-6 Control parameters
Parameter No. Name
P1091 Skip frequency
P1101 Skp frequency bandwidth
P1120 Ramp-up time
P1121 Ramp-down time
P1130 Ramp-up initial rounding time
P1131 Ramp-up final rounding time
P1132 Ramp-down initial rounding time
P1133 Ramp-down final rounding time
P1215 Holding brake enable
P1216 Holding brake release delay
P1217 Holding time after ramp down
P1230 BI: Enable DC braking
P1232 DC braking current
P1233 Duration of DC braking
P1236 Compound braking current
P1310 Continuous boost
P1311 Acceleration boost
P1312 Starting boost
P1910 Select motor data identification
P2200 Enable PI controller
P2231 Setpoint memory of PI-MOP
P2240 Setpoint of PI
r2262 Filtered PI setpoint after RFG
r2272 PI scaled feedback
r2273 PI error
P2291 PI output upper limit
P2292 PI output lower limit
r2294 Actual PI output
Table 7-7 Protection specific parameters
Parameter No. Name
P0011 Lock for user defined par.
P0012 Key for user defined par.
P0013 User defined parameter
P0210 Supply voltage
Parameter list
SINAMICS V10
Operating Instructions, 08/2011, A5E03453178 (this is not an order number) 77