6.5 Inverter status display
Inverter status display
DC voltage
Press
Output voltage
Output current
Frequency
OK
Press
OK
Press
OK
Press
OK
Figure 6-16 Inverter status display
Frequency setpoint and actual value changeover
Different from "Output current", "Output voltage" or "DC voltage" display, after switching to the
"Frequency" status display, you can change between frequency setpoint and actual frequency
displays.
When motor starts running, the frequency setpoint appears and inverter status indicator for
"SETTING" is visible. You can change the setpoint by turning the OK button. When stop turning
OK, the value shown is an actual value and the inverter status indicator for "SETTING"
becomes invisible.
Automatically
after 3 seconds
(Initial setpoint)(Decreased setpoint)
(Increased setpoint)
. . .
(Actual frequency value)
Turn
SETTING
SETTING
SETTING
SETTING
OK
Turn
OK
Turn
OK
Figure 6-17 Frequency status changeover (example)
Note
The default display at first power-on is the frequency. To change the default display, go to
P0005. If you don't turn OK for about 30 seconds, the display automatically switches back to
the value set via P0005.
The frequency value may increase or decrease by 1 Hz or 0.1 Hz, depending on the speed
at which you turn OK.
Commissioning
6.5 Inverter status display
SINAMICS V10
Operating Instructions, 08/2011, A5E03453178 (this is not an order number) 65
To Next Page
Loading...
