EasyManua.ls Logo

Siemens SINUMERIK 808D

Siemens SINUMERIK 808D
339 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
23
4.
Open the menu items for cutting edge settings.
5.
Press this softkey to create a new cutting edge for the selected tool. The control sy
s
tem
automatically ad
ds the new cutting edge to the tool list. Now you can enter different
lengths and radii for each cutting edge.
6.
You can also press the corresponding softkey
to reset or delete a cutting edge.
6.3
Activating the tool and the spindle
Note
A tool in the tool list is not active until you activate it in "MDA" mode or the "T, S, M" window.
Operating sequence
1.
Select the machining operating area.
2.
Switch to "JOG" mode.
3.
Open the "T, S, M" window.
4.
Enter the desired tool number (for example, 1) in the "T, S, M" window.

Table of Contents

Other manuals for Siemens SINUMERIK 808D

Related product manuals