EasyManua.ls Logo

Siemens SINUMERIK 808D

Siemens SINUMERIK 808D
339 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
291
A.2.1.4
Face milling
Fu n ctionality
Use this function to prepare a blank for the subsequent machining without creating a special part program.
Operating sequence
1.
S
elect the desired operating area.
2.
Switch to "JOG"
mode.
3.
Open the face milling window.
4.
Move the cursor keys to navigate in the list and enter the de
sired values for the selected
parameters (see table below for the parameter descriptions).
5.
Confirm you
r entries with the appropriate key.
6.
Select the cu
tting path of the tool during machining.
7.
Use this
softkey to confirm your settings. The system now automatically creates the part
program.
8.
Press this key on the MCP to run the part program.

Table of Contents

Other manuals for Siemens SINUMERIK 808D

Related product manuals