EasyManua.ls Logo

Siemens SINUMERIK 808D

Siemens SINUMERIK 808D
339 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
119
11.10.4
Selecting the tool radius compensation: G41, G42
Fu n ctionality
The control system is working with tool radius compensation in the selected plane G17 to G19.
A tool with a corresponding D number must be active. The tool radius compensation is activated by G41/G42. The control
system automatically calculates the required equidistant tool paths for the programmed contour for the respective current
tool radius.
See the following illustration for tool radius compensation:
Programming
G41 X... Y...
; Tool radius compensation left of contour
G42 X... Y...
; Tool radius compensation right of contour
Note
The selection can only be made for linear interpolation (G0, G1).
Program both axes of the plane (e.g. with G17: X, Y). If you only specify one axis, the second axis is automatically
completed with the last programmed value.
See the following illustration for compensation to the right/left of the contour:

Table of Contents

Other manuals for Siemens SINUMERIK 808D

Related product manuals