Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
285
Sets the NC, PLC and HMI start up modes
Sets the system machine data
â‘¢
Configures the connected drives an
d motors (PPU16x.3 and PPU15x.3 only)
Provides PLC commissioning and diagnostics
Sets the system date and time and adjusts the brightness of the screen
Backs up and restores system data
Creates and restores startup archives, data archive
Performs the axis optimization (PPU16x.3 and PPU15x.3 only)
Enters the corresponding password (manufacturer password, and end user password) for different access levels
Changes the password as per the corresponding access levels
⑪
assword
Selects the user interface language. Note that the HMI is automatically restarted when a new language is selected.
Switches to the ISO programming mode
Saves the contents of the volatile memory into a non
-volatile memory area
An extended horizontal softkey bar can be accessed via this key
on the PPU. Two extended horizontal
Views the service information
Defines the maintenance planner
To Next Page
Loading...
Need help?
General
