Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
35
Edit the program text in the program editor window using the following keys on the PPU:
When necessary, select the following vertical softkeys to complete more program editing
operations.
Renumbering program blocks
With this softkey, you can modify the block numbering (Nxx) of a program opened in the
program editor window. After you press this softkey, the block number is inserted at the
beginning of the
program block in ascending order and is increased by an increment of 10
(for example, N10, N20, N30).
Searching and replacing in programs
Pressing this softkey opens the search dialog box. You can use the search function to
quic
kly arrive at points where you would like to make changes, for example, in very large
You can search with specified text or line number by selecting the corresponding softkey as
follows:
If more than one search result is found, you can also use the following softkey to check the
remaining results one by one:
You can search and replace with specified text by using the following softkey:
If more than one search result is found, you can also use the following softkey to replace the
remaining results one by one:
Copying/deleting/pasting program blocks
A. Press this softkey in the open program editor window to insert a marker.
B. Select the desired program blocks with the cursor.
To Next Page
Loading...
Need help?
General
