Siemens SINUMERIK 840D

11.03 Foreword
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
vii
Documentation with Edition date 04/99 describes the scope of functions of the
following products and SW versions:
SINUMERIK 840D/611 digital with software version 4.4.18
The following table lists the main functions for SINUMERIK 840D/611 digital
added since 08.97 Edition:
Table 0-2 New functions described in 04/99 Edition
Serial no. New functions in SINUMERIK 840D/611 digital, SW 4.4.18 and higher
1 External STOPs
2 Safe programmable logic (SPL)
Note
The documentation with Edition date 05.00 describes the scope of
functions of the following products and software version:
SINUMERIK 840D with software version 5.3
SIMODRIVE 611 digital with software version 5.1
The following functions added since 04.99 Edition are described in 05.00
Edition for SINUMERIK 840D/611 digital:
Table 0-3 New functions described in 05.00 Edition
Serial No. New functions in SINUMERIK 840D/611 digital
1 SPL expansions (Chapter 3)
2 Drive systems with slip (Chapter 3)
3 Setpoint velocity limiting (Chapter 3)
4 Engineering examples (Chapter 7), extended
5 Application examples (Chapter 8), extended
Note
The documentation with Edition date 03.01 describes the scope of
functions of the following products and software version:
SINUMERIK 840D with software version 6.1
SIMODRIVE 611 digital with software version 5.1.10
The following functions added since the 04.99 Edition are described in the
03.01 Edition for SINUMERIK 840D/611 digital:
Table 0-4 New functions described in 03.01 Edition
Serial No. New functions in SINUMERIK 840D/611 digital
1 SPL start without axial safety enable (Chapter 3)
2 New system variables (Chapter 3)
3 Actual value crosswise data comparison error (Chapter 3)
4 Additional machine data (Chapter 4)
5 Additional alarms (Chapter 6)
Documentation with
Edition date 05.00
Documentation with
Edition date 03.01