Siemens SINUMERIK 840D

Foreword 11.03
© Siemens AG 2003 All Rights Reserved
viii SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
Note
The documentation with Edition date 07.02 describes the scope of
functions of the following products and software version:
SINUMERIK 840D with software version 6.3.21
SIMODRIVE 611 digital with software version 5.1.14
The following functions added since the 03.01Edition are described in the 07.02
Edition for SINUMERIK 840D/611 digital:
Table 0-5 New functions described in 07.02 Edition
Serial No. New functions in SINUMERIK 840D/611 digital
1 NCU onboard I/Os (Chapter 3)
2 NC internal pulse disable (Chapter 3)
3 SPL module brake test, safe brake test (Chapter 8)
4 Disable SPL module (SW relay) (Chapter 3)
5 Improved diagnostics (Chapter 5)
6 PROFIsafe (Chapter 3)
Note
The documentation with Edition date 11.03 describes the scope of
functions of the following products and software version:
SINUMERIK 840D with software version 6.4
The following functions added since the 07.02 Edition are described in the
11.03 Edition for SINUMERIK 840D/611 digital:
Table 0-6 New functions described in 11.03 Edition
Serial No. New functions in SINUMERIK 840D/611 digital
1 ProgEvent (Chapter 3.10.10)
2 STOP E (Chapter 3)
3 Acceptance test support (Chapter 5.4)
4 Drive bus failure (Chapter 3.13)
Ordering data option
In this documentation you will find the symbol shown on the left with a
reference to an ordering data option. The function described will only be able
to be used if the control contains the designated option.
The following danger and warning symbols are used in this document.
Explanation of symbols used:
!
Danger
This symbol indicates that death, severe personal injury or substantial
property damage will result if proper precautions are not taken.
Documentation with
Edition date 04/02
Documentation with
Edition date 11/03
Danger and warning
concept