2.8.5 Inserting SINUMERIK MC
Description
A SINUMERIK MC comprises an open-loop control-specific part (PLC, CP, NC) and a PC-
specific part (PC system).
When creating a SINUMERIK MC in the TIA Portal, all subcomponents and the PC system are
simultaneously created.
PROFINET is used for the internal communication between the various components.
Precondition
● A project is open in the TIA Portal.
● The project view is active.
Procedure
Proceed as follows to insert a SINUMERIK MC into the project:
1. Click "Add new device" in the project tree.
2. Click on "Controllers".
Fundamentals
2.8 Device configuration
Safety Integrated (with SINAMICS S120)
Commissioning Manual, 02/2020, A5E46305916B AB 37
To Next Page
Loading...
