Siemens SINUMERIK MC - Safety Components and Licensing; Software Components Required

2.9 Safety components and licensing
2.9.1 Software components required
When configuring the system, the licensed STEP 7 Safety Advanced option package is
required. This option package is integrated in the package "SIMATIC STEP 7 Professional (TIA
Portal) V16".
Engineering system:
● SIMATIC STEP 7 Professional V16
– SIMATIC STEP 7 Safety Advanced V16
● SINUMERIK MC STEP 7 Toolbox V16
● Startdrive V16
● SINAMICS firmware V5.2
CNC software:
● SINUMERIK CNC software V1.13
● SINUMERIK ONE Commissioning Tool V4.93
This tool is a reduced basic version of SINUMERIK Operate.
Fundamentals
2.9 Safety components and licensing
Safety Integrated (with SINAMICS S120)
Commissioning Manual, 02/2020, A5E46305916B AB 51