Siemens SINUMERIK Series

Procedure
1. Select the "Parameter" operating area.
2 Press the "Work offset" and "Overview" softkeys.
The "Work Offsets - Overview" window opens.
4.8.3 Displaying and editing base zero offset
The defined channel-specific and global base offsets, divided into coarse and fine offsets, are
displayed for all set-up axes in the "Zero offset - Base" window.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Procedure
1. Select the "Parameter" operating area.
2. Press the "Zero offset" softkey.
3. Press the "Base" softkey.
The "Zero Offset - Base" window is opened.
4. You can edit the values directly in the table.
Note
Activate base offsets
The offsets specified here are immediately active.
Setting up the machine
4.8 Zero offsets
Milling
148 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0