Siemens SINUMERIK Series

Execution in manual mode
5
5.1 General
Always use "JOG" mode when you want to set up the machine for the execution of a program
or to carry out simple traversing movements on the machine:
● Synchronize the measuring system of the controller with the machine (reference point
approach)
● Set up the machine, i.e. activate manually-controlled motions on the machine using the
keys and handwheels provided on the machine control panel.
● You can activate manually controlled motions on the machine using the keys and
handwheels provided on the machine control panel while a part program is interrupted.
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 163