Siemens SINUMERIK Series User Manual

5. Press the <SINGLE BLOCK> key again, if the machining is not supposed
to run block-by-block.
The key is deselected again.
If you now press the <CYCLE START> key again, the program is execu‐
ted to the end without interruption.
Machining the workpiece
6.3 Testing a program
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 193

Siemens SINUMERIK Series Specifications

General

Axes Control	Up to 31 axes
Category	Control Unit
Manufacturer	Siemens
Series	SINUMERIK
Control Type	CNC
Communication Interfaces	Ethernet, USB
Operating Temperature	0°C to 45°C
Protection Class	IP20
Power Supply	24V DC
Display	Color TFT LCD