Procedure
1. Select the "Program" operating area.
2. Press the "Edit" softkey.
3. Press the ">>" and "Settings" softkeys.
The "Settings" window opens.
4. Make the required changes.
5. Press the "Delete mach. times" softkey if you wish to delete the machining
times.
The machining times that have been determined are deleted from the
editor as well as from the actual block display. If the machining times are
saved to an ini file, then this file is also deleted.
6. Press the "OK" softkey to confirm the settings.
See also
Replacing program text (Page 216)
Machining the workpiece
6.10 Editing a program
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 225
To Next Page
Loading...
