<NEXT WINDOW> + <CTRL> + <SHIFT>
● Moves the cursor to the beginning of a program.
● Moves the cursor to the first row of the current column.
● Selects a contiguous selection from the current cursor position
up to the target position.
● Selects a contiguous selection from the current cursor position
up to the beginning of the program.
<PAGE UP>
Scrolls upwards by one page in a window.
<PAGE UP> + <SHIFT>
In the program manager and in the program editor from the cursor
position, selects directories or program blocks up to the beginning
of the window.
<PAGE UP> + <CTRL>
Positions the cursor to the topmost line of a window.
<PAGE DOWN>
Scrolls downwards by one page in a window.
<PAGE DOWN> + <SHIFT>
In the program manager and in the program editor, from the cursor
position, selects directories or program blocks up to the end of the
window.
<PAGE DOWN> + <CTRL>
Positions the cursor to the lowest line of a window.
<Cursor right>
● Editing box
Opens a directory or program (e.g. cycle) in the editor.
● Navigation
Moves the cursor further to the right by one character.
<Cursor right> + <CTRL>
● Editing box
Moves the cursor further to the right by one word.
● Navigation
Moves the cursor in a table to the next cell to the right.
<Cursor left>
● Editing box
Closes a directory or program (e.g. cycle) in the program editor.
If you have made changes, then these are accepted.
● Navigation
Moves the cursor further to the left by one character.
<Cursor left> + <CTRL>
● Editing box
Moves the cursor further to the left by one word.
● Navigation
Moves the cursor in a table to the next cell to the left.
Introduction
2.2 Operator panel fronts
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 29
To Next Page
Loading...
Need help?
General
