Parameter Description Unit
ZD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
● For blank description, cylinder
– Version, absolute:
Cylinder dimension (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
● For blank description, allowance
– Allowance on the CYCLE62 finished part contour (inc)
mm
Allowance Allowance for pre-finishing - (only for ∇∇∇)
● Yes
U1 contour allowance
● No
mm
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
● Positive value: Compensation allowance is kept
● Negative value: Compensation allowance is removed in addition to finishing
allowance
mm
* Unit of feedrate as programmed before the cycle call
Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description Value Can be set in SD
Residual material Without subsequent residual material removal No
PL Machining plane Defined in MD
52005
SC Safety clearance 1 mm x
DI Continuous cut - (only for ∇) 0
Set machining area
limits
Set machining area limits No
N Number of grooves 1
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Milling
626 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
