Procedure
1. The magazine list is open.
2. Press the "Delete all" softkey.
- OR -
Press the "Unload all" softkey.
- OR -
Press the "Load all" softkey.
- OR -
Press the "Relocate all" softkey.
A prompt is displayed as to whether you really want to delete, unload,
load or relocate all tools.
3. Press the "OK" softkey to continue with deleting, unloading, loading or
relocation of the tools.
The tools are deleted, unloaded, loaded or relocated in the magazine in
ascending magazine location number order.
4. Press the "Cancel" softkey if you wish to cancel the unloading operation.
Multiple load points
For a magazine, if more than one loading point was set-up, using the "Select loading point"
softkey, you have the option of opening a window in which you can assign a loading point to
a magazine.
Tool management
13.8 Magazine
Milling
722 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
