Procedure
1. Select the "Parameter" operating area.
...
2. Press the "Tool list", "Tool wear" or "Magazine" softkey.
3. Press the ">>" and "Filter" softkeys.
The "Filter" window opens.
4. Activate the required filter criterion and press the "OK" softkey.
The tools that correspond to the selection criteria are displayed in the list.
The active filter is displayed in the window header.
Tool management
13.13 Filtering the tool management lists
Milling
732 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
