Siemens SINUMERIK Series

5. Press the "Paste" softkey.
An appropriate note is displayed if a directory/program with the same
name exists in this directory. You are requested to assign a new name,
otherwise the directory/program is assigned a name by the system.
If the name contains illegal characters or is too long, a prompt will appear
for you to enter a permissible name.
6. Press the "OK" or "Overwrite all" softkey if you want to overwrite existing
directories/programs.
- OR -
Press the "No overwriting" softkey if you do not want to overwrite already
existing directories/programs.
- OR -
Press the "Skip" softkey if the copy operation is to be continued with the
next file.
- OR -
Enter another name if you want to paste the directory/program under
another name and press the "OK" softkey.
Note
Copying files in the same directory
You cannot copy files to the same directory. You must copy the file under a new name.
Managing programs
14.9 Copying and pasting a directory/program
Milling
772 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0