Editing events
1. Activate the required check box and press the "Details" softkey.
The appropriate window opens (e.g. "Measuring cycle messages for
workpieces") and shows a list of the defined alarm numbers.
2. Select the corresponding entry and press the "Delete" softkey to remove
the alarm number from the list.
- OR -
Then press the "New" softkey if you wish to create a new entry.
The "Create new entry" window opens.
Enter the data and press the "OK" softkey to add the entry to the list.
Press the "Save" softkey to save the settings for the result.
3. Press the "Standard" softkey to return to the standard settings for the
events.
Easy Message (828D only)
20.4 Setting-up events
Milling
886 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
