See also
HMI menu structure (Page 237)
7.1.3 Operation view
● The operation view can be displayed in up to six user-configured views. Switch manually
between the enabled views with the keys
and . The actual operator view number (1 to
6) is shown in the upper right corner of the figures below.
The view types including the number of process values shown in the operation view are
configured in HMI menu structure (Page 237).
In view 1 only measurement or diagnostic views can be selected. In views 2 to 6 all view types
can be selected.
Navigation view can only be accessed by pressing the right key in a measurement or a
diagnostic view.
● Measurement views
– Single value
– Three values
– One value and bargraph
– One value and graph
– Six values
● Operating views
– Totalizer
– Dosing
● Alarm view
– Alarm List
● Diagnostic view
– Six Diagnostic Values
In general, all of the HMI views show the following:
Operating
7.1 Local operation (HMI)
SITRANS FC330
110 Operating Instructions, 01/2019, A5E44030648-AB
To Next Page
Loading...
