Siemens SITRANS FC330 - Parameter View

The selected parameter can be edited in the parameter view.
Figure 7-5 Navigation view Read only
The selected parameter can only be viewed in the parameter view.
7.1.9 Parameter view
Depending on your access level, you can edit the value of the selected parameter or read the
current value.
Numeric parameters edit view
Numeric parameters in edit view are displayed as shown below.
6
3
1
2
7
5
8
4
① Parameter name
② Parameter item number
③ Maximum value
④ Escape without saving (frame around ESC is only shown when cursor is in left-most position)
⑤ Confirm and save (frame around OK is only shown when cursor is in right-most position)
⑥ Value to be edited
⑦ Minimum value
⑧ Help text describing the parameter function. The help text appears if no key is pressed for three
seconds.
Figure 7-6 Numeric parameter edit view
Operating
7.1 Local operation (HMI)
SITRANS FC330
Operating Instructions, 01/2019, A5E44030648-AB 119