Siemens SITRANS FC330 - Fault codes and corrective actions

Info icons
Icon Name Description
Read only
● Write access disabled
● Indicate read only parameters
Data exchange
● Device is communicating
Custody transfer enabled N/A
Memory card Capacity is 25 % used
Memory card Capacity is 50 % used
Memory card Capacity is 75 % used
Memory card Capacity is 100 % used
10.2 Fault codes and corrective actions
10.2.1 Sensor diagnostics
ID Icons Message Cause/Action
36 Sensor supply volt. out of
range
Contact your local Siemens representative.
37 Sensor supply volt. out of
range
Contact your local Siemens representative.
38 Temperature measure‐
ment fault
Turn off the power, wait 5 seconds and turn on the power
again. If the problem persists, contact your local Siemens
representative.
Diagnostics and troubleshooting
10.2 Fault codes and corrective actions
SITRANS FC330
Operating Instructions, 01/2019, A5E44030648-AB 171