Figure 3-3 Remote version - terminated cable
Figure 3-4 Remote version with wallmount housing transmitter
3.2.2 Sensor design
All primary process measurements of mass flow, volume flow, density and process
temperature are made in the DSL.
The sensor comprises two parallel bent tubes welded directly to the process connections at
each end via a manifold. The sensor is available in an intrinsically safe (IS) design for
hazardous area installations.
The sensors are available in AISI 316L stainless steel and C4 (2.4610) nickel alloy or C22
(2.4602) nickel alloy. The enclosure is made of Stainless steel 1.4404 (AISI 316L), 1.4301 (AISI
Description
3.2 Design
SITRANS FC330
Operating Instructions, 01/2019, A5E44030648-AB 23
To Next Page
Loading...
